Questions and plumbing advice in the Central Heating Forum - Also see on the electrical forum: Central Heating Systems..
Some popular plumbing forums: Plumbing Advice - Plumbing Tools - Plumbing Courses & NVQ's
Forum Prefix Filter
Hi everyone!
My Worcester Greenstar 30CDi Combi boiler started making a rather loud juddering noise two nights ago. I bled all the radiators and releaaed air from the system. Repressurised the system afterwards with the water valve and the noise had stopped... until about the same the next day...
Ive just moved into a rented property and some of the radiators were very cold at the top so I bled the radiators.
The boiler lost pressure and switched off.
I've repressurised the boiler to 1.5 but the controller on the boiler is completely off and I have no idea how to turn the thing back on...
Got some quotes for a service, one person has said if I haven't had the burner seal replaced for past 5 years, it should be done (& service price goes up by £55).
Boiler installed in 2015 - never had the 'seal' replaced? Is it a necessary requirement just as a matter of course?
If the bath top shower is used by turning on the cold tap first, then the hot supply, it will give a consistent short shower, but that is getting shorter day by day before it goes cold.
If the hot is turned on first, then the cold, that will result in domestic supply going cold within a few...
Hi, I am handy DIYer but not interested in touching anything boiler related! Just interested before I get a Gas safe engineer out what I could be looking at for what the problem is and rough cost. So in a nutshell, I put a radiator on in a room in the extension, noticed after that the pressure...
Plumber says the heat exchanger aluminium baffles are breaking down and blocking the pipe which he showed me,now the question is do I change the heat cell or go for a new boiler.
My boiler is 13 years old.
Condensing boiler installed by local Gas Safe plumber in 2014, not combi. Failed a couple of weeks ago with flashing blue light which googling suggests means no gas, blocked flue or blocked condensate pipe. There is gas, the flue is clear, and the condensate pipe goes into the under-sink waste...
- Question
We have a Worcester green star 30si boiler
Hot water is fine.
Ch temp is set at 70 degrees but boiler heats to 68 quite fast then takes ages to heat to 72 when it finally pumps round system,
Seems to be on constant low burn?
Does anyone know if you can buy an adaptor to fit on the unions of the worcester filter so you can connect magnaclense power flush machine connections ?
Hi
I am new to this forum and looking for some help with an annoying issue with my Worcester CDi boiler ( installed about 2010 ). It provides heating and hot water ( through a separate lagged water tank).
Over a year ago it started going into a mode for a number of minutes before it then...
ive been having problems with my boiler banging at night so ive had all my radiators changed and on Saturday had M C 3+ cleaner through the system and sentinel x100 inhibitor put in the boiler was fine that night
Sunday night about 3 in the morning the boiler banged then i could hear a woosh of...
Hi I'm new here so go canny with me.
Hoping that someone can help with the following concerning weather comp, it is a Worcester Bosch comfort+ll control and in the menu it asks to set these values.These are what my thoughts are, are these correct. I am aiming for around 20c for the room...
Hi all
What kind of time is required to replace the Pressure Relief Valve and the expansion chamber in a 6 year old Worcester Bosch i30 Greenstar? Is this a 3 hour job?
Also what kind of price would be reasonable? I am using a new gas engineer and I want to verify that his bill is fair. I am...
I have a greenstar 35cdi combi boiler that when the thermostat calls for heat. It will fire up heat to temp and then drop down to 41* on the boiler display and then kick back in again.
I have checked all wiring and the zone valves. What else could it be? anyone seen this before
Acquaintance has problem with a 5 radiator zoned system which takes ages to heat up. The boiler (don't know output) fires up normally and after ~ 20 minutes reaches its setpoint of 65C, over the next few minutes it will creep up to 70C and then cut out, again fairly normal if min boiler output...
Hi all,
Recently moved into a new house and noticed the Greenstar boiler has low pressure on the dial.
Quick Google suggests using a key, valves, or fill loop to increase the pressure. Only problem being is I don't have either of those things.
Any help would be appreciated.
Cheers.
having a few issues with my boiler. worcester bosch greenstar 28i. has been serviced every year. last serviced in jan. i moved into this property in feb. been experiencing these issues since feb but in the past month has gotten much worse.
so radiators work fine they all heat up. the combi...
Hey Folks.
I have a Worcester Bosch Greenstar 24i Mk4 system boiler that is locked out. The boiler was working correctly, then the gas supply was turned off (to service another appliance) but the boiler was not turned off. I assume that the boiler tried to cycle on and off as requested by the...
Good afternoon everyone, I am hoping you may be able to help me. I have a Worcester Bosch 19/24CBI boiler and it keeps cycling. When trying to heat the hot water (same for heating) the boiler is off more than it is on and thus unless timed for a very long time never gets the desired outcome. In...
My Worcester Bosch boiler works for the central heating system but doesn’t turn on for hot water. On the boiler the chimney sweeper icon is flashing and then 100. Not sure what this means or what I need to do? Can anyone advise as I’m clueless
Creating content since 2001. Untold Media.
Tags
Newest Plumbing Threads
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-