B
buckley plumb
has anyone used the corgi zone valve heads from toolstation they say they fit Honeywell - they are half the price of the Honeywell ones
- Thread starter buckley plumb
- Start date
- Replies 4
- Views 1K
- forum plumbing valve zone zone valve
Discuss zone valve in the Plumbing Zone area at PlumbersForums.net
- Status
I have fitted 2 of the new complete valves and they were much the same as any 2 port. Didn't disconnect heads though so not sure how easy it would be to retrofit.
Wouldn't normally use toolstation stuff, but custard self diagnosed and supplied (wasn't actually the MV it was programmer)
Wouldn't normally use toolstation stuff, but custard self diagnosed and supplied (wasn't actually the MV it was programmer)
- Messages
- 3,017
Thought they would save money?I have fitted 2 of the new complete valves and they were much the same as any 2 port. Didn't disconnect heads though so not sure how easy it would be to retrofit.
Wouldn't normally use toolstation stuff, but custard self diagnosed and supplied (wasn't actually the MV it was programmer)
- Status
Reply to zone valve in the Plumbing Zone area at PlumbersForums.net
Similar plumbing topics
Hi all I'm hoping someone can shine a light on this for me
Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall)
Unfortunately turning this to the closed position only reduces...
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Has anyone one fit or serviced one of these before; Heatrae Sadia 25l 9004010.
It a 25 litre hot water storage cylinder.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
-
-
-
-
-
-
Sewer pipe problems not sure about it- Started by sammie81116
- Replies: 3
-
-
-
-
My son has an Apprentice interview- please help.
- Started by LadsDad
- Replies: 3
-
-
-
UK Can't get stopcock 100% closed to allow a tap repair
- Started by DIY disaster
- Replies: 1
-
