Search the forum,

Discuss What make of radiator in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
F

Funkyboy123

Hi All,

I'm looking to changeover four radiators of varying sizes and was looking for a recommendation of what make of radiator to go for?

Thanks for your help
 
I use ultra heat can remove the grills for easy cleaning
 
Whatever I can get hold of.

Centerrads from plumb are good. Made by Stelrad. Myson made them previously which I preferred. But you can strip the panels and hang upside down for a roundtop finish.

Fitted a few Instinct which are ok and kudox from plumbase. Well wrapped now.
 
Purmo radiators from plumbase are good quality look good and have a 10year warranty , if your watching the pennies instinct from plumb city do the job . Cheers kop
 
Status
Not open for further replies.

Reply to What make of radiator in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
229
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
465
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
217
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
127
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
226
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock