Search the forum,

Thunderflush dual installation problem

Post new thread

Discuss Thunderflush dual installation problem in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

A

Andy Thomson

I have just installed a Thunderflush dual flush cistern outlet valve. The unit sits to high for the lid and buttons to sit and engage as they should. I have adjusted the button height fully yet it is still about 8mm too high. What can be done?
 

Reply to Thunderflush dual installation problem in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

M
Unvented discharge at high level current regs
Hi they used to say as a last resort you could discharge the D2 pipework at high level and turn it back to the wall. Similar to a combi boiler. I have just looked back through the regs this seems to have changed and it isn't mentioned now. It now mentions if at high level it should be discharged...
Replies
11
Views
262
Matt0029
M
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
130
Lou
Lou
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
190
Timmy D
T
S
Using coil to clear pipe leading to gutter
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and pebbles!) We saw that the pipe that takes water down the gutter was visibly full to the top. He said he will return with a coil to push through...
Replies
1
Views
62
Chuck
C
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
230
DIwhYdidIstartThis
D
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forums
UK Tiling Forum
Tiling Blog
Electricians Talk
BS 5389 Tiling Standards
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock