Search the forum,

Discuss Regs for boilers in loft space in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

shyguy2005

Gas Engineer
Messages
159
Anyone know where I can find regs for boiler in loft spaces?
 
Didn't know there were any! Common sence would say have loft boarded out and at least have a light! BG with there health and safety will want hand rails loft ladder and a mum to hold their delicate hands!
Boiler would need a frost stat, can't think of anything else!
 
Permanent light, floor and ladder
 
not in the doc J building regs?
its written somewhere for proper loft ladder, light and flooring right upto and under installation.
 
But most importantly, make sure the customer is able to get up in the loft to repressurise or reset the boiler, lots of old people who have them in lofts aren't able to get up there!!
 
Probably find you'll have to take the ladder out to push the boiler through the loft hatch! Make sure Yer loveslave is underneath pushing up!! Because Yer don't want a boiler landing on Yer swede!!!!!
 
not in the doc J building regs?
its written somewhere for proper loft ladder, light and flooring right upto and under installation.

WB stipulate in there installation instructions I think.
 
But most importantly, make sure the customer is able to get up in the loft to repressurise or reset the boiler, lots of old people who have them in lofts aren't able to get up there!!
Get stanna to put a stair lift in, it'll be easier to get the boiler up!!!!
 
But most importantly, make sure the customer is able to get up in the loft to repressurise or reset the boiler, lots of old people who have them in lofts aren't able to get up there!!

been to a few where filling loop and gauge put in airing cupboard.
 
Anytime a boiler is in a loft always put a remote filling loop and gauge in
 
Status
Not open for further replies.

Reply to Regs for boilers in loft space in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
188
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
205
Does anyone know a good, not super expensive, leak detection company in the London area?
Replies
0
Views
285
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
123
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
175
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock