Search the forum,

Magnaclean seals

Post new thread

Discuss Magnaclean seals in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
B

Backboiler

Plumbers Arms member
Plumber
Gas Engineer
Messages
396
Does anyone know if the lid seal in a Magnaclean Micro 2 is the same size (same part) as an ordinary Magnaclean?
 
Yea it is the early magnacleans (red valve) are different if you order the seals set should come with both.
 
I phoned Adey and they told me the Micro 2 and Professional 2 share a different seal kit to the Magnaclean 1.
Thanks for your comments guys
 
Status
Not open for further replies.

Reply to Magnaclean seals in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
Brass tap body is leaking.
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed. Is there a seal behind the body? Thanks.
Replies
2
Views
292
Bp89
B
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
181
ShaunCorbs
ShaunCorbs
J
Leak detection company
Does anyone know a good, not super expensive, leak detection company in the London area?
Replies
0
Views
292
John-sjw
J
T
Trying to source a dual-flush valve
Does anyone know where I can get one of these? Toilet is leaking into the bowl. This one pushes in with a half turn but I can't find one anywhere.
Replies
2
Views
190
Thomas J Marshall
T
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
177
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock