Search the forum,

Kitchen sink waste pipes

Discuss Kitchen sink waste pipes in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
D

DaveRoberts

Is there any way to set this configuration up without drilling a new hole into the wall? The new sink is in a slight different position to the previous setup. Any suggestions? Thanks, Dave
IMG_2723.jpg
 
Thas a mess, the outlet looks higher going out wall than u will get away with for that depth of sink. My advice would be to trap the sink properly and bite the bullet and drill new hole out as would be neater job than what is in just now
 
Status
Not open for further replies.

Reply to Kitchen sink waste pipes in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
5
Views
131
DIwhYdidIstartThis
D
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
201
Dave Moore
D
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
118
dreikher
dreikher
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
255
Chuck
C
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
115
ChrisGid
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock