Search the forum,

Discuss GRANT Air Source Heat Pumps in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
No I don't but there is not much to see from outside and would need rather a large memory card to photograph the entire installation it's a big place....
 
On another note I evaluated a install in kidderminster. Long story short 30W per square meter was calculated for the heat output which would not have been too far wrong exept for 3.6m room height throughout the whole building plus a massive amount of glazing on the first floor and second floor and nearly half of the roof.
My report to the specifier was entertaining.
 
sounds like you need soft start fitting my boss had one fitted at a cost of £250
 
no news they were meant to have done it three weeks ago but nowt happened will ask and see whats going on with it. think in my earlyer post the price is wrong wasnt particularly listening was about 7pm on a friday :26:

can the air source be staggered somehow so they dont start at exactly the same time?
 
Last edited by a moderator:
Status
Not open for further replies.

Reply to GRANT Air Source Heat Pumps in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
193
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
300
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
3
Views
354
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock