Search the forum,

Glow worm energy.......

Discuss Glow worm energy....... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Scott_D

Scott_D

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
6,131
Does anyone fit these?
You don't hear much about them good or bad!
 
I service a few not bad but you can tell there cheap

Everything is easy to service easy plate swap etc
 
Is it a wash the heat exchanger out annual service? Like a logic?
 
Is there a fan pressure to go by or just every few years clean out
 
Ever had to call out glow worm for s warranty repair?
Just Vaillant guys I guess
 
No thank god but spoke to them a couple of times better off speaking to monkeys

And yes
 
Status
Not open for further replies.

Reply to Glow worm energy....... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

J
Leak detection company
Does anyone know a good, not super expensive, leak detection company in the London area?
Replies
0
Views
291
John-sjw
J
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
469
Chuck
C
M
heatrae sadia 25l 9004010.
Has anyone one fit or serviced one of these before; Heatrae Sadia 25l 9004010. It a 25 litre hot water storage cylinder.
2
Replies
39
Views
627
John.g
J
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
180
ShaunCorbs
ShaunCorbs
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
175
SimonG
SimonG
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock