Search the forum,

Connecting a WC to 4" fitting

Discuss Connecting a WC to 4" fitting in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
E

EPH

Plumbers Arms member
Plumber
Messages
1,182
Anyway of taking a pan spigot straight into a 4" tee without a pan connector?
 
P or S trap?
Concealed connection or exposed?

More info or photo would be good
 
Status
Not open for further replies.

Reply to Connecting a WC to 4" fitting in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
251
ShaunCorbs
ShaunCorbs
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
300
Chuck
C
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
224
exedon2
exedon2
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
162
SimonG
SimonG
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
166
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock