- Messages
- 21
Hi guys I'm looking at glueing some hdpe, can it be done with an epoxy resin and if so any recommendations thanks in advance
- Thread starter bobbychocolate
- Start date
- Replies 3
- Views 885
- glue
Discuss Can I glue hdpe?? ?????? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 1,337
HDPE was always welded using heat so the two parts were effectively melted together. Now there are epoxy resins that can do it, as you suggest. The preparation is really important. What are you joining the HDPE to?
Here you go. How to Glue HDPE | Hunker
Here you go. How to Glue HDPE | Hunker
- Messages
- 34,309
- Solutions
- 2
As above but watch your drying times some want 2 days
- Status
Reply to Can I glue hdpe?? ?????? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi,
My current hot water system needs to be replaced.
Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off?
An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au.
How reliable is this...
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Hello all,
I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Hi All
I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Hello all,
I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-