Search the forum,

Discuss Atag boilers in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
D

Deleted member 56158

Afternoon all, just wondered if any of you have had any dealings with Atag boilers, as the mobile unit is calling at our offices tomorrow for a demonstration and possible partnership between us.
Many thanks.
 
Only commercial. Seem pretty good, I'm sure the domestics will be similar quality.

I'm planning on looking into those, Post again when you've seen em and let us know your thoughts please
 
Only commercial. Seem pretty good, I'm sure the domestics will be similar quality.

I'm planning on looking into those, Post again when you've seen em and let us know your thoughts please
 
Only commercial. Seem pretty good, I'm sure the domestics will be similar quality.

I'm planning on looking into those, Post again when you've seen em and let us know your thoughts please
Afternoon, just to let you know that we were very impressed with ATAG boilers, there domestic boiler are high spec, super efficient (even in hot water). All steel heat exchangers, manifolds all brass, long warranties (up to 10 years) & lots of models to choose from. We've applied to be part of their installer membership. Can't say fairer than that really.
 
Afternoon, just to let you know that we were very impressed with ATAG boilers, there domestic boiler are high spec, super efficient (even in hot water). All steel heat exchangers, manifolds all brass, long warranties (up to 10 years) & lots of models to choose from. We've applied to be part of their installer membership. Can't say fairer than that really.

Thanks for letting us know. I will take a look at those.
 
Good Boilers, just a bit of an unknown for customers
 
I was told by the Atag rep to direct any potential customers to the trust pilot web site for feedback from genuine Atag customers, hope that helps.
 
Status
Not open for further replies.

Reply to Atag boilers in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
193
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
181
  • Sticky
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from each main country too. I'll post this in the Australian forum now.
Replies
0
Views
50
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock