Search the forum,

shower attachment

The shower-curtain effect in physics describes the phenomenon of a shower curtain being blown inward when a shower is running. The problem of identifying the cause of this effect has been featured in Scientific American magazine, with several theories given to explain the phenomenon but no definite conclusion.
The shower-curtain effect may also be used to describe the observation how nearby phase front distortions of an optical wave are more severe than remote distortions of the same amplitude.

View More On Wikipedia.org
  1. J

    Recommendations for reliable bath-taps with shower attachment

    I'm looking for deck-mounted taps for a low-to-medium head. Access once installed will be near impossible so the taps ned to be reliable. Recommendaitons and "avoid at all cost" advice appreciated. John
  2. P

    Shower hose on tap without fitting

    Hi everyone, my bath tap has no fitting on its end. How could I connect a shower hose? Thanks!
  3. D

    Grohe Avensys Classic replacement control alternative

    The plastic temperature control knob on my Grohe Avensys Classic shower has broken. It's a small piece of chrome-effect plastic this size of a tuppence. The full assembly, including the replacement part is around £115. This is rather annoying as I only need the smallest part of the assembly...
  4. P

    Leaking bathroom Waterfall mixer tap with shower attachment

    Hi to everyone, newbie here. I have a waterfall mixer tap with a shower attachment which has started leaking. I have replaced both the ceramic disc cartridges, ensuring that everything was clean before hand but its still leaking. To enable the shower, you lift a knob which is situated in the...
  5. G

    Looking for mixer taps with shower attachment unusual size.

    Hi I am reusing an old cast iron bath but when measuring the distance bettween center of tap holes the results came out 7.5 inch (190mm). I notice all the mixers with attachments are usually 180mm so will I just have to settle on single taps or can I buy 190mm mixers?
  6. D

    Bath mixer tap with shower attachment

    Can I fit a standard bath mixer tap with shower attachment to my system. I have mains pressure cold supply but the hot is low pressure from a hot water cylinder. Any advice would be greatfully recieved. Thanks
  7. R

    Help requested with Bath Shower Attachment Valve Failure

    Hi all - I am new to this but I hope you can help me a little. I put this on the valves & taps forum but have had no answers yet but fewer peole seem to look at that so here goes again... with pictures! We have an old cast iron bath with the mixer tap with a valve to divert the water to the...
  8. R

    Bath / Shower Taps - Failed switching valve

    Hi all - I am new to this but I hope you can help me a little. We have an old cast iron bath with the mixer tap with a valve to divert the water to the shower head. A traditional style one - two taps connecting in the centre to the shower diverter valve & then to one central spout. This...
  9. R

    Bath / Shower Taps - Failed switching valve

    Hi all - I am new to this but I hope you can help me a little. We have an old cast iron bath with the mixer tap with a valve to divert the water to the shower head. A traditional style one - two taps connecting in the centre to the shower diverter valve & then to one central spout. This...
  10. R

    Taps.

    Hi Folks, I'm fitting a bathroom in a few weeks and need to source some taps for the customer. I'm after a set of Bath deck mixer taps with an integrated shower attachment and matching basin taps - does anyone have any recomendations? I've got around £150 to spend on the taps. Cheers, Pete.
  11. P

    Eago Whirlpool Bath

    Hi All, Fitted one of these about six weeks ago, was a nice job (thankfully in a bungalow, concrete floor as its a touch on the heavy side), if a little awkward as the taps and the shower head fitting were all connected in the centre of the bath on the underside up against the wall. When I left...
  12. W

    Hot cold water pressure

    Been to look at a job where the customer requires a few things doing. One of them he wants to change the bath mixer with shower attachment. The trouble is the cold is mains supply so washes out the hot. I have explained to the customer this isnt ideal, but was thinking of changing the bath...
  13. B

    Could somebody help me please ? Water pressure with shower attachment problem

    Hi, Please excuse my ignorance and barefaced cheek coming on here, Im not a plumber but I have a problem with some plumbing work thats being done and Im not sure if Im being fobbed off. Ive had a new bathroom installed and prior to this had two seperate bath taps that had quite good water...
  14. A

    Bath shower mixer taps

    Hello all just a quick question to reassure my self really. iam going to change some ordinary bath taps for bath shower mixer taps with shower attachment the hot water is provided by a combi boiler,can i just put a standard pair of mixer taps on or should i go for thermostatic ones.was a bit...
  15. A

    Need a bit of guidence

    Hi All. I need a little bit of guidence i know you can get replacement valves for taps but my problem is i have bath taps with the shower attachment on them.With the valve set for taps its fine but for the shower it just dribbles out.Is it possible to change the valve that diverts the water...
  16. B

    Hot water pressure low

    Hi, Hope someone can help here goes, I have just installed a whirlpool jacuzzi bath with a mixer hand held shower attachment all connections are half inch. The problem is the pipe to the hot water is 22mm so I have made this down to a 15mm and 15mm isolation valve connected to 15mm flexi hose...
  17. C

    water flow

    i removed old bath taps and replaced them with ceramic disc one the flow has been reduced y is this the taps r ment 4 hi and low pressure systems all the pipes r 22mm and it has full bore lever valves with double check valves as stated in the instructions aswell as the water regs .does the check...
  18. R

    Mixer tap pipes wrong way round???

    Hello please help, just fitted a bath mixer tap with shower attachment trouble was the hot and cold pipes were opposite to the unit and as it was difficult to get into i have connected hot pipe to cold outlet and vica verca, now the cold water pressure is fin but the hot warter pressure is vey...
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock