You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
removal
Indian removal was the United States government policy of forced displacement of self-governing tribes of Native Americans from their ancestral homelands in the eastern United States to lands west of the Mississippi River – specifically, to a designated Indian Territory (roughly, present-day Oklahoma). The Indian Removal Act, the key law which authorized the removal of Native tribes, was signed by Andrew Jackson in 1830. Although Jackson took a hard line on Indian removal, the law was enforced primarily during the Martin Van Buren administration. After the passage of the Indian Removal Act in 1830, approximately 60,000 members of the Cherokee, Muscogee (Creek), Seminole, Chickasaw, and Choctaw nations (including thousands of their black slaves) were forcibly removed from their ancestral homelands, with thousands dying during the Trail of Tears.Indian removal, a popular policy among white settlers, was a consequence of actions by European settlers in North America during the colonial period and then by the United States government (and its citizens) until the mid-20th century. The policy traced its origins to the administration of James Monroe, although it addressed conflicts between European and Native Americans which had occurred since the 17th century and were escalating into the early 19th century (as white settlers pushed westward in the cultural belief of manifest destiny). Historical views of Indian removal have been reevaluated since that time. Widespread contemporary acceptance of the policy, due in part to the popular embrace of the concept of manifest destiny, has given way to a more-somber perspective. Historians have described the removal of Native Americans as paternalism, ethnic cleansing, or genocide.
I need to change the washer on the dripping hot tap in the photo, does anybody know how to remove the dome tap handle, there's no fixings or grub screw anywhere, thanks
Is there anything in the regs that I’m unaware off to stop us from removing a radiator permanently?? Silly question no doubt.
When removing new build rads, that are obviously piped in plastic, are you just cap ending them and pushing them in the wall or going back to a fitting in the floor...
Hi Everyone,
I hope someone might be able to help please. I hope this isn't a daft question.
I am trying to remove the side panels on my radiator to get in to clean it, but they seem to be secured by a small screw underneath (on the valve housing).
Can someone please advise me if I can just...
My bathroom Basin was installed some years ago by a professional plumber. For whatever reason, the waste was fitted using silicone rather than plumber’s mate. The floor was originally tiled, but I replaced it with high quality vinyl, when fractures began to appear in the grout. As part of this...
The system is open vented with a Glowworm boiler. It has an LCD controller on the wall - see pic.
I just want to remove one radiator for cleaning and decorating the room. I will put it back the same day.
If I switch the hot water and central heating off on the LCD controller several hours...
I'm removing a Trevi CTV but struggling removing the volume control handle. The temperature control knob is removed but I can't see how to remove the volume control handle. It won't budge. Does it just clip off?I
Any help would be appreciated
Thanks
I am trying to replace the cartridge for a waterfall tap (mixer mono) for the bathroom sink, I have run into a problem whereby I cannot remove the cartridge as the usual 32mm nut is recessed and I cannot get to it. The tap is from screwfix (
NIAGARA WATERFALL BASIN MONO MIXER TAP)
I have...
I live in an apartment and have a cold water tank in it. The cold water tank feeds the cold water tap in the sink and the bath. Recently, I refurbished my bathroom and, according to the plumber that fitted the new taps, high-pressure taps were fitted. Consequently, the water that comes out of...
Hello.need a little help.
I have a water meter under kitchen sink next to stop tap and a water meter outside under the pavement. Can I remove the meter under the kitchen sink?
Would anyone be able to advise how to remove the thermo cartridge from these shower taps ?
The cartridge has a notch in it which means it can't turn.
This is a square shower set, and Im not sure the make,...maybe Victoria Plum ?
If you can advise on the manufacturer name, then that would be...
Hi
I need to pull out a drawer base unit from my bathroom, not fitted by me.
I have removed most screws but I am faced with one of these in each top corner inside the unit, which I belive are called wall bracket hangers.
There is screw as pictured, then another single screw underneath.
The...
Good day fellow plumbers.
As the title says, what do you use to extract rusty screws from boilers? Vailliant and glow worm plates and the bottom screw on the diverter ?
Cheers
Help please can anyone tell me how to remove this older model Francis Pegler shower backplate, there are no signs of a grub screw
or a socket headed screw. It cant be rotated either because of the border tiles. Thanks
Hello, I am trying to replace the cartridge but I can not see where is the grub screw, please find the picture and kindly advise how I can remove the cartridge. Regards
Hi All, I have this monobloc basin mixer tap in my bathroom. It was installed 11 years ago, but the hot valve has started to drip from the top around the tap head. Problem is I don’t know how to get to the valve. There are no grub screws visible and I’ve tried to remove the valve cover but it...
We bought a new build. After 11 years the boiler had gone and we get a new one fitted. The pipework I want sorting out (like that from new build) as we are getting a new kitchen and boxing it in is a pain.
The filter hangs very low down. Do we really need this? Pipework would hang down a lot...
Hi All,
This is a rare visit to your forum for me as I try to avoid plumbing and get the pro's in however, even I can change a tap washer right? Well, apparently not!
I removed the cap, undid the cross head screw and do you think the tap/knob would come off? Not on your life! I've tried a...
I am having issues with my Concealed Shower Valve, Its blending too hot, ive put this down to the shower cartidge probably needs a clean as its only been working ok for a year.
Shower is fed on a 1.5bar pump with header tank.
my main issue though is ive moved all the knobs and faceplate but to...
Just bought a property that needs lots of work doing so decided CH to be the first to start with.
Old system was 20yrs old so decided on a 35Kw Ideal boiler to be installed by a Gas safe installer.
Despite fairly shoddy work in places the boiler seems to function OK but when I went into the...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.