Hi
I am replacing suspect diverter valve on old Worcester Bosch 28cdi. There is a small black slotted screw there (see the photo).
Could someone advise me what is it for, is it an adjustment?
Thank you very much
Rafal
Hi All,
I wonder if anyone could give me some advice regarding a Worcester 28cdi ii , I get hot water only at certain times when the central heating is on and even then the hot water is in short supply, there is a tank next to the boiler.
Is there a way of having hot water all time when needed...
Ok, following on from my drain tap thread, does anyone have an opinion about this vibration noise. It started a few days ago there's no lockout or fault code and everything works as it should except for the noise. I fancy it's the pump but as they go for about £150 I want to be as sure as i can...
Hi all, new to the forum, I have an old style Worcester 28cdi that I need to drain down to investigate some vibration noise. (i'll be asking opinions about that once the youtube video has finished uploading), meantime my question is; when you open the boiler drain taps, nothing happens. does...
Hi all, i went to service one off these today but i had to abandon and say i'll be back in a couple of days. This has really throughn me badly and its the first time i've attempted to service one of these aswell so no prior knowledge.
A bit of background british gas have "serviced" it for the...
Hi
Choosing a new replacement Worcester Bosch combi boiler - both are about the same price.
Anyone have experience of what the noise levels are like - the WB website says 52 decibels for the small one and 50 decibels for the larger - but what are they like in real life over the longer term...
Worcester 28cdi pressure rising over 24hr period from 1 bar to 2 bar when nothing running...? Filling key left out.
I'm thinking heat ex. Anyone else had anything like this?
I'm replacing the PRV on a Worcester 28 CDi, but the space between the red cap and the side of the boiler housing is only about 5mm. The o-ring PRV body is inserted approximately 12mm in to the clipped housing.
Does it slide out when the union is unbolted or is there further dis- assembly...
Hi all,
I'm looking for some advice.
About 18 months ago we purchased a house that had this boiler already in it, on completion we wanted it serviced, saw it was old as far as boilers go and it was.
Had no problems with the boiler until it was serviced in December just gone. Something that...
Hi guys
Went to look at a Worcester 28cdi rsf today.
G.C 47 311 34
The vertical flue doesn't quite look right to me, as in doesn't look like a Worcester fitting. But I can't find any instructions for the vertical flue and it's not in the boiler installation instructions. Does anyone know...
I have a Worcester 28CDI and recently I have noticed that the pressure is going from 1 bar cold up to the maximum 4bar within 20 minutes when turning the central heating on. There is also water leaking from the bottom of the boiler. The heating and hot water seem to be functioning fine. I've...
jpb1980
Thread
28cdi
color
engineer
leak
pressure
system
worcester
I have a Worcester 28CDI and recently I have noticed that the pressure is going from 1 bar cold up to the maximum 4bar within 20 minutes when turning the central heating on. There is also water leaking from the bottom of the boiler. The heating and hot water seem to be functioning fine. I've...
Unregistered
Thread
28cdi
boiler
central heating system
leak
pressure
water
worcester
Called out to a worcester 28cdi ( not greenstar, old one with grey front) making a strange noise, little bit of banging etc. I think it's the pump, turns out that the pump only works on speed 3 and if you turn it to speed 2 or 1 it stops and obviously starts banging loads.
Obviously there is...
Hi guys,
been out to this boiler, it's a combi but it's not a sealed system it's tank fed.
never seen this before.
customer has complained that hw is intermittent. Colleague of mine has said change the plate. I'm not entirely convinced, went through fault finding, checking pressures and...
So I went out for a service a week ago and they said it stops working and the hot water light flashes (air pressure fault).
I wasn't 100% certain what it was I narrowed it down to the fan slowing down for a split second when it gets hot or the aps drops out for a second and it cuts out...
Hi
I would appreciate some advice as my boiler has a small leak from cold water feed
at the back of boiler. The bit where the copper pipe feeds into the cold water inlet filter.
Is it possible to fix this easily myself, or how much would it cost for a plumber to fix.
Thanks
jim
jimmaynard
Thread
28cdi
boiler
bosch
casing
cold
cold water
filter
gasket
inlet
water
worcester
worcester bosch
Good evening all,
New joiner here and hopeful that you may be able to offer some advice regarding my 28CDi. THe CH side of things is fine however when there is a draw on the hot water the light turns on and you can hear the burners starting and then the water temp keeps rising irrespective of...
baz995
Thread
28cdi
before
burners
hot
hot water
plumbing
temp
water
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.