Search the forum,

Recent content by Ulsinus

  1. U

    Blanco Kitchen Tap Model Swift BM1420 dismantling instruction

    Hi, My Blanco Kitchen Tap Model Swift BM1420 is leaking. Please see attached photos for details of where water leaks from. What I've done so far. I replaced the cartridge. Leak persisted. Bought some replacement seals and tried to put in place of the old ones. Here's what I did next. Remove...
  2. Blanco Swift Tap (1).JPG

    Blanco Swift Tap (1).JPG

  3. Blanco SWift Tap (2).JPG

    Blanco SWift Tap (2).JPG

  4. Blanco Swift Tap (1).JPG

    Blanco Swift Tap (1).JPG

  5. Blanco SWift Tap (2).JPG

    Blanco SWift Tap (2).JPG

  6. U

    Ideal Icos HE30 boiler start-up sequence

    Thanks for the info regarding the start-up sequence. Very helpful. My user documentation doesn't contain these. Least ways not so clearly. I have now gone back as you suggested, shut everything down as before, and restarted from scratch. The good news is that the boiler fired up. Heating ok. DHS...
  7. U

    Ideal Icos HE30 boiler start-up sequence

    My Ideal Icos HE30 boiler has been reliable starter since its installation 12 year's ago. It has been serviced every year since by the original installer. Today the boiler failed to fire though the thermostat is calling for heat. I replaced the batteries in the thermostat. I turned the...
  8. U

    Icos He30 combi boiler resolution L9/H9 fault codes

    Hi, I have resolved the issue. I bought a set of clamps. The source of the problem I believe was this: 'In the heating season ... I increase the boiler temperature control to near maximum.' The boiler was simply running too hot. I have set the flow temperature to approximately 65 degrees C with...
  9. U

    Icos He30 combi boiler resolution L9/H9 fault codes

    Thanks Brambles and I totally agree.
  10. U

    Icos He30 combi boiler resolution L9/H9 fault codes

    Thanks Brambles. Sadly that horse has bolted. I mean to say the annual visit was last week and he didn't do it then. So I'm reluctant to spend another £100. 1605623550 Thank you Brambles for highlighting this particular hazard. Much appreciated.
  11. U

    Icos He30 combi boiler resolution L9/H9 fault codes

    What should the temperature values be?
  12. U

    Icos He30 combi boiler resolution L9/H9 fault codes

    Thank you Townfanjon for your reply and advice. A couple of more questions if I may. Can you explain what his 'clamps' are and why they are relevant in finding the problem? Is it a problem if the pressure is left at 2 bar. Is there some sort of pressure sensor in the boiler controls that would...
  13. U

    Icos He30 combi boiler resolution L9/H9 fault codes

    Thank you Aquarius for your prompt and helpful reply.
  14. U

    Icos He30 combi boiler resolution L9/H9 fault codes

    My boiler is an Ideal Icos HE30 boiler. This supplies the central heating and a separate heat store - in other words a big cylinder - for domestic hot water. It is not a combi boiler. The boiler is 10 years old and it has been serviced by the original installer each year since installation. It...
  15. U

    Weeping WC cistern siphon/flush pipe joint repair

    In the end I managed to get access to the base of the cistern by removing the built-in cupboard to the left of the pan. Then with the help of a friend, who held the top of the siphon, and using a Thomas Dudley 4-in-1 Universal Toilet Spanner I managed to tighten the flush flange nut...
Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock