Hi. Asking for a relative whose neighbour seemingly DIYed an oil tank replacement. She was aware of 'oil' smells at regular times in the weeks following this, although that has since died down.
Is there a way of checking whether the installation was registered, a bit like boiler installs?
Thanks.
Hi. Having recently qualified in oil(yet to do any oil in the real world), I was wondering where the best place is I can get the manuals from for all the different oil boilers please? Also been called today about a service on a Camray 2 that hasn't been serviced for years....any advice after a...
The use of inserts on 10mm rolls of plastic covered copper. Brass inserts are available for this purpose, but does anyone use them. They have an O/D of 7.7mm where as the I/D of all of the coils available to me are 8.6 min.
I fitted this boiler some 18 years ago it's now time for a upgrade and the client has asked me to find a suitable replacement , I am not really doing oil installs any longer so I would appreciate some guidance on a suitable replacement please , I did think of a external boiler but this may...
Looking to renew my certs. Noticed there is now an OFTEC training place in Aberdeen near me.
dropped them a note asking about availability and price of the 3 day course...
£1150... plus vat.
HOW MUCH !!!
Madness......
My apologies as this question has probably been asked loads of times.
We moved into a new house in Jan which has an oil boiler, the room that houses the boiler is always warm, sometimes like an oven.
The radiator that's directly above where the boiler is is always on, mainly warm but sometimes...
Builder at my house went through oil line has been repaired and oil purged back to boiler. Now it wont fire but it doesn't lock out either. Motor runs, fan runs. It goes to fire but then wont hold the flame. keeps trying to ignite every 15 seconds but never locks out. I have checked photocell...
Hi everyone, i was wondering if anyone could help me with the name (if they have one) of the following arrowed parts and where i can purchase them from?
Your help would be much appreciated.
Thanks in advance.
Hi I had a boiler fitted about 18 months ago and have found out that it was never registered and I can't get hold of company what should I do
Thanks Darren
Hi,
Firstly, I am neither plumber nor heating engineer, just a willing diy, have a go guy.
I have a Grant 26 oil fired combi boiler which started continually leaking water from the prv to the outside. The pressure was at 1 bar until the heating system cut in, when it would increase to 2.5 and...
My Danesmoor is on last legs. Actually was when I posted on here two years ago asking about Firebird as a replacement, but limped along. Now however the writing really is on the wall so need to replace this summer.
Heating engineer is wedded to Firebird but not heard good things about out of...
At a warmflow bluebird today not firing.I checked there was 240v going into the rdb control which there was
so immediately got a control from the van but no dice same issue.So im getting 240v on my meter but no lockout light .Nothing completely dead.I plugged a mains powered grinder into the...
My boiler began to lock out occasionally every now and then.
Got it serviced
continued to lock out getting more frequent
An engineer came, changed the fire lock out, changed the pump, changed some braided leads to the burner
no change
I clean the oil filter near the tank
I replace the capacitor...
I have been using a Stanley stove with a back boiler for the past ten years. We are now converting to gas and have disconnected the stove from the mains. We would like to keep the stove but I am concerned about how safe/unsafe that might be. I lit a fire and as I had been told, we had a sauna...
Anyone got any suggestion on how, if possible you could clear soot from the condensing heat exchanger of a Grant Vortex. Have many of you encountered blockages like this? Have any of you been able to avoid condemnation of the boiler the due to the stainless heat exchanger being blocked? What can...
With regs requesting more oil line pressure testing, what's the best way to test an existing oil line with a tiger loop.
Can you leave it in place or do you exclude form test. ?
Hi all.
Okay.
Long storey but, I'll try & keep it as short as possible.
We are buying a house that is in a little rural village so no gas. A guy bought it to renovate & sell over but it appears, bit off a little more than he can chew as apparently he usually buys cheap properties, toshes them...
Looking to replace our RIELLO 40 FS10 (3758435) Gas burner - 0.13kW, FAM.OIK.2 =12 -100mbar (42-116kW) but can no longer see the availability of this particular burner. Looks like it has a newer model that may have superseded it. Am I right in saying the replacement would be the RIELLO 40 GS10...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.