Questions and plumbing advice in the Oil and Solid Fuel Forum - .
Some popular plumbing forums: Plumbing Advice - Plumbing Tools - Plumbing Courses & NVQ's
Hi, we have Worcester Bosch heatslave external oil boiler 18/25
Boiler locked out. Pressure was below 0.5 so brought pressure back up. When lock out is reset the burner attempts to light but sounds like a bag of spanners and cuts out again smelling strongly of oil. We have plenty of oil & the...
Hi all.
I am thinking about how to get the most from pv panels. I have a worcester Green star oil Combi boiler about 5 years old.
If I install a mains pressure immersion tank can I convert the boiler to a non combi type? And heat the water in the tank with the boiler.
Also is it possible to...
Heatslave II 25/32 water leak from PHE Inlet block. When DHW PRV fitting was removed a white flat seal/washer was found in 3 pieces. This seal is not listed on any diagram. It sits ahead of the rubber o ring item 45 on drawing and has has the same ID and OD as the oring but is made from white...
Had a leak on oil tank pipe fitting landlords plumber has said leak was due to small elevation on back of tank “brick” I know it’s bad practice not disputing that but I say olive was never fitted correctly as it’s loose on pipe please see attached vid any opinions would be appreciated
Hi. Currently experiencing an issue with our oil fired central heating system. When CH/HW is switched on, the central heating does not always work - the hot water does however without fail. We had the timer set to come on last night but alas, only the H/W came on. After a couple of hours of...
Hello, ive been to a greenstar worcester bosch combi , with intermittent lock out , I've traced it back to the flue, with the burn air intake pipe pipe removed the boiler will not lock out , but when it is fitted it lockds out. now that shows me that the air intake side of the flue is either...
I have been using a Stanley stove with a back boiler for the past ten years. We are now converting to gas and have disconnected the stove from the mains. We would like to keep the stove but I am concerned about how safe/unsafe that might be. I lit a fire and as I had been told, we had a sauna...
Closed heating system, approx 14 years old with oil fired boiler, feeding around 18 radiators over 2 floors. One small radiator nearest the boiler and downstairs repeatedly fills up with hydrogen over a period of about 4 weeks. Hydrogen is suspected as it can be ignited and there is no smell...
Hi,
We had our annual oil burner service carried out by a well known Norfolk firm last Thursday and all was great for a day. Came home from work on Friday evening to find our 15+ year old HRM Wallstar burner had locked out. I pressed the lockout button only to find it would lockout 1 to 2 mins...
Why are all these boilers supplied with a clear plastic fuel line?.
I fitted this boiler some 18 years ago it's now time for a upgrade and the client has asked me to find a suitable replacement , I am not really doing oil installs any longer so I would appreciate some guidance on a suitable replacement please , I did think of a external boiler but this may...
Hi,
Newbie here so feel free to teach me the etiquette of this place, and apologies for the lengthy opening post.
The boiler started locking out on Friday after a long period of faultless running, there was a bit of gunk on the back of the (newish) nozzle (Danfoss Nozzle 0.65 x 80 EH) ...
Evening All,
We've just moved into gas boilers (after years doing gas) and are currently tooling up. On our first install we had problems bending the 10mm plastic coated, white pipe. Possibly because of the sub-zero conditions the covering shattered when we bend it by hand. It measures 12mm...
Can I get a backboiler connected to an indirect vented hot water cylinder through the existing small bore coil which was used previously for a pumped oil boiler, ie do I have to get a new tank with a wide bore gravity feed coil (and scrap the present hot tank?)
I understand the pump would have...
We have a 9 yr old Heatslave 18/25 that's been regularly serviced. Heating was on in the morning but failed in the evening. My son is Gas safe engineer and suggested trying a few things before calling our usual engineer.
He disconnected the twin channel control panel and put in link's so it is...
Hi
I have a worcester heatslave external oil boiler which makes a large bang every time we use hot water when the central heating is running. It seems that as the diverter valve moves towards the hot water position there is a single clunk which can be heard all around the house. The diverter...
Hi,
I have a Warmflow 70/90 deluxe oil boiler (approx. 23 years old) and the high limit thermostat has tripped (I probably had the boiler stay turned up too high). The orange light is on but I can’t seem to locate the reset button on this model anywhere.
If anyone can point me in the right...
The boiler has just been serviced and lots of new parts fitted, On firing up all works fine for approx 15 seconds then the flame cuts out but the motor keeps running, after approx 10 seconds the flame fires up again for 15 seconds and the same thing happens. If I remove the front door/cover of...
Hi,
My regular plumber is a good guy but getting reponse from my regular plumber (and the previous one) where I live is rubbish at the best of times. And in the current climate, getting anyone else is proving (understandably) impossible
The valve, circled in white in the attached pic is...
Hi all, new owner here looking for advice ...
There is a Grant Euroflame 70/90 oil-fired boiler with two pumps but no motorised valves. I assume one pump is CH and the other for DHW, so the valves are not needed. There is a cylinder stat and a Sangamo Choice PR2 two-channel programmer wired to...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 3
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-
-
Sewer pipe problems not sure about it- Started by sammie81116
- Replies: 3
-
-
-