Results 1 to 5 of 5
Plumbing & Plumbers Forum - zone valve actuator motor
zone valve actuator motor
Discuss zone valve actuator motor in the Central Heating Forum at Plumbers Forums; anyone know of any instructions on how to change a motor? tried it a couple of times but failed. any suggestions would be appreciated!...-
24-04-2010 #1Plumbing Forum Contributor
- Join Date
- Dec 2009
- Location
- South Wales
- Posts
- 32
- Thanks
- 0
- Thanked 0 Times in 0 Posts
zone valve actuator motor
anyone know of any instructions on how to change a motor? tried it a couple of times but failed. any suggestions would be appreciated!
-
24-04-2010 #2uɐɯ sɐƃ moderator
- Join Date
- Jan 2010
- Location
- maesteg,south wales
- Posts
- 13,564
- Thanks
- 836
- Thanked 1,284 Times in 1,225 Posts
Re: zone valve actuator motor
eh.. its not rocket science m8,what are you unsure off?
GASMAN
fear keeps you alive
fearless gets you killed
IMPORTANT: Carbon Monoxide can be produced when ANY fuel is burnt, including oil, gas, wood and coal.
GSR?want gas safety or boiler repair advice?we will check out that your genuine via the gas safe website,so please dont be offended when we ask for your details
diyers,potchers,odd job people and have a go heroes need not apply
BAXI/POTTERTON INSTALLER/SERVICE ENGINEER
land rover equipped,you can go faster,i can go anywhere
-
24-04-2010 #3Banned
- Join Date
- Jul 2009
- Location
- North Devon
- Posts
- 1,889
- Thanks
- 5
- Thanked 86 Times in 76 Posts
Re: zone valve actuator motor
unclip the drive unit and replace with new drive unit, simpleessss Not being funny but if you cant change a sychron motor just fit a new motor drive to the valve, take the old one home and have a practice slow time.
-
25-04-2010 #4Plumbing Forum Contributor
- Join Date
- Dec 2009
- Location
- South Wales
- Posts
- 32
- Thanks
- 0
- Thanked 0 Times in 0 Posts
Re: zone valve actuator motor
when i take the motor out and put the new one in its as if the cogs underneath dont realign properly and just doesnt work properly.
-
25-04-2010 #5Plumbing Forum Contributor
- Join Date
- Feb 2010
- Posts
- 75
- Thanks
- 0
- Thanked 0 Times in 0 Posts
Re: zone valve actuator motor
Are you removing the Actuator from the valve to do this?
Originally Posted by evsy01
If so, you should lock the valve into the open position before removing it otherwise you can have problems with the cogs
Reply With QuoteSimilar Threads
-
Central Heating and Hot Water Control problem
By WHPES in forum Central Heating ForumReplies: 2Last Post: 16-12-2009, 05:33 PM -
MP valve in mid postion with HW Only on
By daveywavey in forum Central Heating ForumReplies: 1Last Post: 14-10-2009, 10:43 PM -
Adding a UFH zone to a Y Plan system
By Rhodp in forum Plumbing ForumReplies: 1Last Post: 16-07-2009, 08:14 PM -
Whats this valve for?
By plotnine in forum Central Heating ForumReplies: 2Last Post: 14-09-2008, 06:05 PM
Help needed with Honeywell st6400c...
1 Minute Ago in Plumbing Forum